Art

IC MCT2E DATASHEET PDF

MCT2 and MCT2E are also available in white package by . MCT2E. MCT2E-M. MCT V. (IC = 16 mA, IF = 32 mA, TA = °C). Details, datasheet, quote on part number: MCT2E Collector-emitter saturation voltage Input-to-output internal resistance TEST CONDITIONS = 10 µA, IC =1. MCT2E ON Semiconductor / Fairchild Transistor Output Optocouplers DIP-6 PHOTO TRANS datasheet, inventory & pricing.

Author: Daikasa Banos
Country: Australia
Language: English (Spanish)
Genre: Personal Growth
Published (Last): 12 November 2011
Pages: 462
PDF File Size: 17.43 Mb
ePub File Size: 8.76 Mb
ISBN: 669-5-86777-546-1
Downloads: 21869
Price: Free* [*Free Regsitration Required]
Uploader: Dajin

Submitted by admin on 7 March This will short the collector and emitter and hence the Logic Output voltage will become zero. Then Pull high the collector pin of the transistor using a resistor here I have used 1K and connect the collector pin to the output of your desired logic circuit.

MCT2E Datasheet, PDF – Alldatasheet

Connected to isolated ground. This is where the isolation occurs.

It is normally not used for transistor mode, but will be used in diode mode. When the IR led is powered the light from it falls on the dstasheet and it conducts.

This comes in very handy when you are trying to isolate a noisy signal from your digital electronics, so if you are looking for an IC to datasheeg optical isolation in your datasneet design then this IC might be the right choice for you. This way the logic input will be reflected at the logic output and still provides and isolation between the two. But when the Datashwet input is made high, this high voltage should be a minimum of 1.

This IC is used to provide electrical isolation between two circuits, one part of the circuit is connected to the IR LED and the other to Photo-transistor. The below waveform shows the time taken for the output to transit from one state to another.

MCT2E Datasheet(PDF) – TI store

This is the id output pin 6 Base B Base pin of the Transistor. The complete working can also be understood form the GIF file above.

In the Photo-transistor mode we will not be using the base pin pin 6 of the transistor; we just have to connect the anode pin of the IR LED pin 1 to the logic input which has to be isolated and the cathode pin 2 of the IR led to the ground.

The ground line of the IR LED pin 2 and the ground line of the transistor pin 4 will not be connected together. The Emitter pin 4 is grounded.

IC MCT2E Optocouplers

More details can be found at the MCT2E datasheet which is available for download at the end of this page. TL — Programmable Reference Voltage. The digital signal given to the IR LED will be reflected on the transistor but there will be no hard electrical connection between the two.

Out of which the Phototransistor mode is mostly used, so let us look at that mode first. There pull-up resistor 1K acts as a load resistor.

Base pin of the Transistor. Another important parameter to consider while using an Optocoupler, is the rise time tr and fall time tf. The output will not get high as soon as the input logic is catasheet low and vice versa.