HIgH TO LOW CONVERTER. – SIgNAL TAp mETHOd fOR AddINg SubWOOfERS if you wish to add an amplifier to an existing system to power subwoofers. 18 Jan I read that there has been issues w/ the factory amp and decided NOT to bypass it using the Scosche FAI-3A. However, I have absolutely no. CLICK HERE TO DOWNLOAD.

Author: Tygogal Zusho
Country: Sri Lanka
Language: English (Spanish)
Genre: Education
Published (Last): 23 March 2004
Pages: 415
PDF File Size: 9.2 Mb
ePub File Size: 19.76 Mb
ISBN: 666-9-28157-449-1
Downloads: 47244
Price: Free* [*Free Regsitration Required]
Uploader: Mizilkree

An aftermarket stereo will most likely sound better than a factory. Then to test it, I simply hooked up a crappy old speaker from a rai and it didn’t work.

In all cases, you may need to adjust the gain with the lil adjusters. Thanks for the help.

GenVibe – Community for Pontiac Vibe Enthusiasts

It’s also possible that the levels need to be adjusted. Who is online Users browsing this forum: No registered users and 0 guests.

Life is a sexually transmitted disease!!! Would I still need a harness kit? I need to hook a stock stereo to a kicker amp. Do I need something else to go with it? It just floats around behind the scosche fai 3a manual. I dont have teh amp yet, im still waiting on that.

Observe polarity positive and negative.

The FAI-3 is working like it’s supposed to, it’s supposed to strip the higher voltage signal out of the HU “speaker outputs” and bring them down to “line level” You won’t be able to hear anything scosche fai 3a manual a speaker on a line level output ok, ok, disclaimer, you might, but it will be very faint and very quiet If you have a boombox with RCA input jacks, you can use that to test the hookups.

Sun Sep 10, 6: Here’s a link to one output converter. I scosche fai 3a manual on another thread that it was. Lately during the filling cycle water hammer is occurring.

The two in the back and the left front still work.

How to hook up Scosche FAI-3A? – GenVibe – Community for Pontiac Vibe Enthusiasts

Then there should be four input wires. Scosche fai-3a how exactly do you hook it up to a stock stereo?

In preparation I installed an amp kit already. All that’s left is scosche fai 3a manual connect the volt power wire to the Amplifier’s Power Terminal and a Manua, wire to scosche fai 3a manual Amplifier’s Ground Terminal. Then simply hook up the RCA jacks to your amp! Read each setting description if you’re not sure which setting to use and that should help determine it. I do have the directions but still not for sure cause it shows hooking up Are you sure you want to delete this answer?

Talk to a Technician Now! So I went back to trade it in. Your answer needs to include more details to help people.

Scosche Fai 3a Diagram

Can’t hurt though if you have a convenient place to ground scosche fai 3a manual. I wanna be sure this one is broke B4 I take the crap back.

With red and white wires. Would I just need to strip the wire from the new majual harness and the harness that’s connected to the vehicle and simply connect to this Scosche using the screws??